1-13
Parameter
None
Description
Use the mac-authenticiaon intrusion-mode block-mac enable command to enable the quiet MAC
function on a port. When this function is enabled, the MAC address connected to this port will be set as
a quiet MAC address if its authentication fails. When this function is disabled, the MAC address will not
become quiet no matter whether the authentication is failed.
Use the undo mac-authenticiaon intrusion-mode block-mac enable command to disable the quiet
MAC function on a port.
By default, quiet MAC function is enabled on a port.
Example
# Enable the quiet MAC function on port Ethernet 1/0/1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] mac-authenticiaon intrusion-mode block-mac enable
mac-authentication max-auth-num
Syntax
mac-authentication max-auth-num user-number
undo mac-authentication max-auth-num
View
Ethernet port view
Parameters
user-name: Maximum number of MAC address authentication users allowed to access a port. This
argument is in the range of 1 to 256.
Description
Use the mac-authentication max-auth-num command to configure the maximum number of MAC
address authentication users allowed to access the port. After the number of access users has
exceeded the configured maximum number, the switch will not trigger MAC address authentication for
subsequent access users, and thus these subsequent access users cannot access the network
normally.
Use the undo mac-authentication max-auth-num command to restore the maximum number of MAC
address authentication users allowed to access the port to the default value.
By default, the maximum number of MAC address authentication users allowed to access a port is 256.
To Next Page
Loading...
Need help?
General