1-20
port-security trap
Syntax
port-security trap { addresslearned | dot1xlogfailure | dot1xlogoff | dot1xlogon | intrusion |
ralmlogfailure | ralmlogoff | ralmlogon }
undo port-security trap { addresslearned | dot1xlogfailure | dot1xlogoff | dot1xlogon | intrusion |
ralmlogfailure | ralmlogoff | ralmlogon }
View
System view
Parameters
addresslearned: Enables/disables sending traps for MAC addresses learning events.
dot1xlogfailure: Enables/disables sending traps for 802.1x authentication failures.
dot1xlogoff: Enables/disables sending traps for 802.1x-authenticated user logoff events.
dot1xlogon: Enables/disables sending traps for 802.1x-authenticated user logon events.
intrusion: Enables/disables sending traps for detections of intrusion packets.
ralmlogfailure: Enables/disables sending traps for MAC authentication failures.
ralmlogoff: Enables/disables sending traps for MAC-authenticated user logoff events.
ralmlogon: Enables/disables sending traps for MAC-authenticated user logon events.
RADIUS authenticated login using MAC-address (RALM) refers to MAC-based RADIUS authentication.
Description
Use the port-security trap command to enable the sending of specified type(s) of trap messages.
Use the undo port-security trap command to disable the sending of specified type(s) of trap
messages.
By default, the system disables the sending of any types of trap messages.
This command is based on the device tracking feature, which enables the switch to send trap messages
when special data packets (generated by illegal intrusion, abnormal user logon/logoff, or other special
activities) are passing through a port, so as to help the network administrator to monitor special
activities.
To Next Page
Loading...
Need help?
General