1-6
Because Smart Link and STP cannot be enabled on an Ethernet port at the same time, you must make
sure that STP is disabled on the port before assigning the port to a smart link group.
Example
# Configure Ethernet1/0/3 as the master port of Smart Link group 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/3
[Sysname-Ethernet1/0/3] port smart-link group 1 master
reset smart-link packets counter
Syntax
reset smart-link packets counter
View
User view
Parameter
None
Description
Use the reset smart-link packets counter command to clear the flush message statistics of Smart
Link.
Example
# Clear the flush message statistics of Smart Link.
<Sysname> reset smart-link packets counter
smart-link flush enable
Syntax
z In Ethernet port view:
smart-link flush enable control-vlan vlan-id
undo smart-link flush enable
z In system view:
smart-link flush enable control-vlan vlan-id port interface-type interface-number [ to interface-type
interface-number ]
undo smart-link flush enable port interface-type interface-number [ to interface-type
interface-number ]
To Next Page
Loading...
Need help?
General