3-13
reboot
Syntax
reboot [ unit unit-id ]
View
User view
Parameter
unit-id: Unit ID of a switch, the value can only be 1.
Description
Use the reboot command to restart a specified Ethernet switch.
Before rebooting, the system checks whether there is any configuration change. If yes, it prompts
whether or not to proceed. This prevents the system from losing the configurations in case of shutting
down the system without saving the configurations.
Example
# Directly restart this switch without saving the current configuration.
<Sysname> reboot
Start to check configuration with next startup configuration file,
please wait......
This command will reboot the device. Current configuration may be lost in next startup if
you continue. Continue? [Y/N] y
This will reboot device. Continue? [Y/N] y
<Sysname>
%Apr 2 00:06:01:148 2006 Sysname DEV/5/DEV_LOG:- 1 -
Switch is rebooting...
Starting......
schedule reboot at
Syntax
schedule reboot at hh:mm [ mm/dd/yyyy | yyyy/mm/dd ]
undo schedule reboot
View
User view
Parameter
hh:mm: Reboot time, where hh (hour) ranges from 0 to 23, and mm (minute) ranges from 0 to 59.
To Next Page
Loading...
Need help?
General