1-10
undo voice vlan qos
View
Interface view
Default Level
2: System level
Parameters
None
Description
Use the voice vlan qos trust command to configure the current interface to trust the priority settings
carried in incoming voice traffic. With this command configured, an interface keeps the CoS and DSCP
values marked for incoming voice traffic unchanged.
Use the undo voice vlan qos command to restore the default.
By default, an interface modifies the CoS value and the DSCP value marked for voice VLAN traffic into
6 and 46 respectively.
Related commands: voice vlan qos.
z Configure the QoS priority trust mode for voice VLAN traffic on an interface before enabling voice
VLAN on the interface. If the configuration order is reversed, your priority trust setting will fail.
z The voice vlan qos command and the voice vlan qos trust command can overwrite the other.
After you execute the two commands on a port multiple times, the one that was last executed takes
effect.
Examples
# Configure interface Ethernet 1/0/1 to trust the priority settings carried in incoming voice VLAN traffic.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] voice vlan qos trust
voice vlan security enable
Syntax
voice vlan security enable
undo voice vlan security enable
View
System view
Parameters
None
To Next Page
Loading...
Need help?
General