1-15
Examples
# Set the errored symbol event triggering threshold to 100.
<Sysname> system-view
[Sysname] oam errored-symbol threshold 100
oam loopback
Syntax
oam loopback
undo oam loopback
View
Ethernet port view
Default Level
2: System level
Parameters
None
Description
Use the oam loopback command to enable Ethernet OAM remote loopback on an Ethernet port.
Use the undo loopback command to disable Ethernet OAM remote loopback.
By default, Ethernet OAM remote loopback is disabled.
Ethernet OAM remote loopback is available only after the Ethernet OAM connection is established
and can be performed only by the Ethernet OAM entities operating in active Ethernet OAM mode.
Related commands: oam enable, oam mode.
Examples
# Configure the active Ethernet OAM mode, enable Ethernet OAM, and enable Ethernet OAM remote
loopback on Ethernet1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] oam mode active
[Sysname-Ethernet1/0/1] oam enable
[Sysname-Ethernet1/0/1] oam loopback
oam mode
Syntax
oam mode { active | passive }
View
Ethernet port view
To Next Page
Loading...
Need help?
General