1-62
timer
Syntax
timer seconds
undo timer
View
RADIUS scheme view
Parameters
seconds: Response timeout time of RADIUS servers, ranging from 1 to 10 seconds.
Description
Use the timer command to set the response timeout time of RADIUS servers (that is, the timeout time
of the response timeout timer of RADIUS servers).
Use the undo timer command to restore the default response timeout timer of RADIUS servers.
By default, the response timeout time of RADIUS servers is 3 seconds.
Note that:
z After sending out a RADIUS request (authentication/authorization request or accounting request)
to a RADIUS server, the switch waits for a response from the server. The maximum time that the
switch can wait for the response is called the response timeout time of RADIUS servers, and the
corresponding timer in the switch system is called the response timeout timer of RADIUS servers.
You can use the timer command to set the timeout time of this timer, and if the switch gets no
answer before the response timeout timer expires, it needs to retransmit the request to ensure that
the user can obtain RADIUS service.
z Appropriately setting the timeout time of this timer according to your network situation can improve
the performance of your system.
z The timer command has the same function with the timer response-timeout command.
Related commands: radius scheme, retry.
Examples
# Set the timeout time of the response timeout timer for RADIUS scheme radius1 to 5 seconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme radius1
New Radius scheme
[Sysname-radius-radius1] timer 5
timer quiet
Syntax
timer quiet minutes
undo timer quiet
To Next Page
Loading...
Need help?
General