1-3
Parameters
interface-type: Interface type.
interface-number: Interface number.
Description
Use the display ip interface brief command to display brief information about a specified or all Layer 3
interfaces.
With no argument included, the command displays information about all layer 3 interfaces; with only the
interface type specified, it displays information about all layer 3 interfaces of the specified type; with
both the interface type and interface number specified, it displays information about the specified
interface.
Related commands: display ip interface.
Examples
# Display brief information about VLAN-interface 1.
<Sysname> display ip interface brief vlan-interface 1
*down: administratively down
(l): loopback
(s): spoofing
Interface IP Address Physical Protocol Description
Vlan-interface1 192.168.0.39 up up Vlan-inte...
Table 1-2 Description on the fields of the display ip interface brief command
Field Description
*down
The interface is administratively shut down with the shutdown
command.
(s)
Spoofing attribute of the interface. It indicates that the interface whose
link layer protocol is displayed up may have no such a link present or the
link is set up only on demand.
Interface Interface name
IP Address
IP address of the interface (If no IP address is configured, “unassigned”
is displayed.)
Physical Physical state of the interface
Protocol Link layer protocol state of the interface
Description
Interface description information.
If the description has no more than 12 characters, the whole description
can be displayed. If it has more than 12 characters, only the first nine
characters are displayed.
ip address
Syntax
ip address ip-address { mask | mask-length }
undo ip address [ ip-address { mask | mask-length } ]
To Next Page
Loading...
Need help?
General