1-1
1 Link Aggregation Configuration Commands
Link Aggregation Configuration Commands
display link-aggregation interface
Syntax
display link-aggregation interface interface-type interface-number [ to interface-type
interface-number ]
View
Any view
Parameter
interface-type: Port type.
interface-number: Port number.
to: Specifies a port index range, with the two interface-type interface-number argument pairs around it
as the two ends.
Description
Use the display link-aggregation interface command to display the link aggregation details about a
specified port or port range.
Note that as ports in a manual link aggregation groups do not acquire the information about their peers
automatically, so the entries in the information about the peer ports displayed are all 0 instead of the
actual values.
Example
# Display the link aggregation details on Ethernet 1/0/1.
<Sysname> display link-aggregation interface Ethernet1/0/1
Ethernet1/0/1:
Selected AggID: 1
Local:
Port-Priority: 32768, Oper key: 2, Flag: 0x45
Remote:
System ID: 0x8000, 0000-0000-0000
Port Number: 0, Port-Priority: 32768 , Oper-key: 0, Flag: 0x38
Received LACP Packets: 0 packet(s), Illegal: 0 packet(s)
Sent LACP Packets: 0 packet(s)
Table 1-1 Description on the fields of the display link-aggregation interface command
Field Description
Selected AggID
ID of the aggregation group to which the specified port
belongs
Local Information about the local end
To Next Page
Loading...
Need help?
General