1-32
Examples
# Enable the ND detection of VLAN 1
<Sysname> system-view
[Sysname] vlan 1
[Sysname-vlan1] ipv6 nd detection enable
ipv6 nd detection trust
Syntax
ipv6 nd detection trust
undo ipv6 nd detection trust
View
Layer-2 Ethernet interface view
Parameters
None
Description
Use the ipv6 nd detection trust command to configure a port as the ND trusted port. Use the undo
ipv6 nd detection trust command to configure a port as the ND untrusted port.
By default, a port is ND untrusted.
Among S3100 series switches, only S3100-EI series switches support the two commands.
Examples
## Configure the Ethernet interface Ethernet1/0/1 on Layer 2 as ND trusted port.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] ipv6 nd detection trust
ipv6 nd snooping enable
Syntax
ipv6 nd snooping enable
undo ipv6 nd snooping enable
View
VLAN view
Parameters
None
Description
Use the ipv6 nd snooping enable command to enable ND snooping.
Use the undo ipv6 nd snooping enable command to restore the default.
To Next Page
Loading...
Need help?
General