1-8
z It is recommended that you use a destination port for port mirroring purpose only. Do not use a
destination port to transmit other service packets.
Related commands: display mirroring-group.
When you configure mirroring destination port on an Ethernet port, if mirroring group 1 does not exist,
the switch creates the local mirroring group 1 and adds the port to the group; if mirroring group 1 already
exists, but is not a local mirroring group, your configuration of the destination port will fail.
Examples
# Configure Ethernet 1/0/4 as a destination port in Ethernet port view.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/4
[Sysname-Ethernet1/0/4] monitor-port
remote-probe vlan enable
Syntax
remote-probe vlan enable
undo remote-probe vlan enable
View
VLAN view
Parameters
None
Description
Use the remote-probe vlan enable command to configure the current VLAN as the remote-probe
VLAN.
Use the undo remote-probe vlan enable command to restore the remote-probe VLAN to a normal
VLAN.
Note that:
z Do not configure the default VLAN (VLAN 1), the port VLAN, or a dynamic VLAN as the remote
probe VLAN.
z A remote-probe VLAN cannot be removed directly. To do that, you need to run the undo
remote-probe vlan enable command in VLAN view first.
Related commands: mirroring-group remote-probe vlan.
Examples
# Configure VLAN 5 as the remote-probe VLAN.
To Next Page
Loading...
