2-6
NTDP Configuration Commands
display ntdp
Syntax
display ntdp
View
Any view
Parameters
None
Description
Use the display ntdp command to display the global NTDP information.
The displayed information includes topology collection range (hop count), topology collection interval
(NTDP timer), device/port forwarding delay of topology collection requests, and time used by the last
topology collection.
Examples
# Display the global NTDP information.
<Sysname> display ntdp
NTDP is running.
Hops : 4
Timer : 0 min(disable)
Hop Delay : 100 ms
Port Delay: 10 ms
Last collection total time: 92ms
Table 2-2 Description on the fields of the display ntdp command
Field Description
NTDP is running. NTDP is enabled globally on this device.
Hops
Hop count for topology collection, which is
configured through the ntdp hop command
Timer
Interval to collect topology information, which is
configured through the ntdp timer command
"disable" means this switch is not a management
device and does not perform periodic topology
collection.
Hop Delay
Delay for other devices to forward topology
collection requests, which is configured through
the ntdp timer hop-delay command
Port Delay
Delay for ports on other devices to forward
topology collection requests, which is configured
through the ntdp timer port-delay command
Last collection total time Time used by the last topology collection
To Next Page
Loading...
Need help?
General