1-19
z If the current port does not belong to any multicast VLAN but it belongs to the specified VLAN, the
configuration takes effect in the specified VLAN.
z If the current port belongs to a multicast VLAN, the configuration takes effect only in the multicast
VLAN no matter the port belongs to the specified VLAN or not.
Examples
# Configure Ethernet 1/0/1 in VLAN 10 as a static router port.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet 1/0/1] multicast static-router-port vlan 10
reset igmp-snooping statistics
Syntax
reset igmp-snooping statistics
View
User view
Parameters
None
Description
Use the reset igmp-snooping statistics command to clear IGMP Snooping statistics.
Related commands: display igmp-snooping statistics.
Examples
# Clear IGMP Snooping statistics.
<Sysname> reset igmp-snooping statistics
service-type multicast
Syntax
service-type multicast
undo service-type multicast
View
VLAN view
Parameters
None
Description
Use the service-type multicast command to configure the current VLAN as a multicast VLAN.
Use the undo service-type multicast command to remove the current VLAN as a multicast VLAN.
By default, no VLAN is a multicast VLAN.
In an IGMP Snooping environment, by configuring a multicast VLAN and adding ports to the multicast
VLAN, you can allow users in different VLANs to share the same multicast VLAN. This saves bandwidth
To Next Page
Loading...
Need help?
General