1-19
The port-security timer disableport command is used in conjunction with the port-security
intrusion-mode disableport-temporarily command to set the length of time during which the port
remains disabled.
Related commands: port-security intrusion-mode.
Examples
# Set the intrusion protection mode on Ethernet 1/0/1 to disableport-temporarily. It is required that
when intrusion protection is triggered, the port be shut down temporarily and then go up 30 seconds
later.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] port-security timer disableport 30
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] port-security intrusion-mode disableport-temporarily
port-security timer guest-vlan-reauth
Syntax
port-security timer guest-vlan-reauth interval
undo port-security timer guest-vlan-reauth
View
System view
Parameters
interval: Time period in the range of 1 to 3600, in seconds.
Description
Use the port-security timer guest-vlan-reauth command to configure the interval at which the switch
triggers MAC address authentication after a port is added to its guest VLAN.
Use the undo port-security timer guest-vlan-reauth command to restore the default.
By default, the switch triggers MAC address authentication at intervals of 30 seconds.
At a certain interval, the switch uses the first MAC address learned in the guest VLAN to trigger MAC
address authentication. If the authentication succeeds, the port leaves the guest VLAN.
Examples
# Configure the switch to trigger MAC address authentication at intervals of 60 seconds.
<Sysname> system-view
[Sysname] port-security timer guest-vlan-reauth 60
To Next Page
Loading...
Need help?
General