1-17
By default, LLDP is disabled globally and enabled on a port.
Note that LLDP takes effect on a port only when it is enabled both globally and on the port.
Examples
# Disable LLDP on Ethernet1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] undo lldp enable
lldp encapsulation snap
Syntax
lldp encapsulation snap
undo lldp encapsulation [ snap ]
View
Ethernet interface view
Parameters
None
Description
Use the lldp encapsulation snap command to configure the encapsulation format for LLDPDUs as
SNAP on a port or a group of ports.
Use the undo lldp encapsulation command to restore the default encapsulation format for LLDPDUs.
By default, Ethernet II encapsulation applies.
The command does not apply to LLDP-CDP packets, which use only SNAP encapsulation.
Examples
# Configure the encapsulation format for LLDPDUs as SNAP on Ethernet1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] lldp encapsulation snap
lldp fast-count
Syntax
lldp fast-count count
undo lldp fast-count
To Next Page
Loading...
Need help?
General