2-10
View
VLAN view
Default Level
2: System level
Parameters
None
Description
Use the mld-snooping enable command to enable MLD snooping in the current VLAN.
Use the undo mld-snooping enable command to disable MLD snooping in the current VLAN.
By default, MLD snooping is disabled in a VLAN.
MLD snooping must be enabled globally before it can be enabled in a VLAN
Related commands: mld-snooping.
Examples
# Enable MLD snooping in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
mld-snooping fast-leave
Syntax
mld-snooping fast-leave [ vlan vlan-list ]
undo mld-snooping fast-leave [ vlan vlan-list ]
View
Ethernet interface view
Default Level
2: System level
Parameters
vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by each of which
you can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of a
VLAN ID is 1 to 4094.
Description
Use the mld-snooping fast-leave command to enable fast leave processing on the current port or
group of ports. With this function enabled, when the switch receives an MLD leave message on a port,
it directly removes that port from the forwarding table entry for the specific group.
Use the undo mld-snooping fast-leave command to disable fast leave processing on the current port
or group of ports.
By default, fast leave processing is disabled.
To Next Page
Loading...
Need help?
General