1-10
Description
Use the info-center monitor channel command to set the channel through which information is output
to user terminals.
Use the undo info-center monitor channel command to restore the default channel through which
information is output to user terminals.
By default, output of system information to the monitor is enabled with a default channel name of
monitor and a default channel number of 1.
This command works only when the information center is enabled.
Related command: info-center enable, display info-center.
Example
# Set the system to output information to user terminals through channel 0.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] info-center monitor channel 0
info-center snmp channel
Syntax
info-center snmp channel { channel-number | channel-name }
undo info-center snmp channel
View
System view
Parameter
channel-number: Channel number, ranging from 0 to 9, corresponding to the 10 channels of the system.
channel-name: Channel name, by default, the name of channel 0 to channel 9 is (in turn) console,
monitor, loghost, trapbuffer, logbuffer, snmpagent, channel6, channel7, channel8, channel9.
Description
Use the info-center snmp channel command to set the channel through which information is output to
the SNMP agent.
By default, output of system information to the SNMP NMS is enabled with a default channel name of
snmpagent and a default channel number of 5.
Related command: snmp-agent, display info-center.
Example
# Set the switch to output information to the SNMP agent through channel 6.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] info-center snmp channel 6
To Next Page
Loading...
Need help?
General