H3C S3100 Series

2-9
Examples
# Enable MLD snooping in VLAN 2 and configure the source IPv6 address of MLD done messages sent
by the MLD snooping proxy in VLAN 2 to FE80:0:0:1::1.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping done source-ip fe80:0:0:1::1
mld-snooping dot1p-priority
Syntax
mld-snooping dot1p-priority priority-number
undo mld-snooping dot1p-priority
View
VLAN view
Default Level
2: System level
Parameters
priority-number: Specifies 802.1p precedence for MLD messages, in the range of 0 to 7. The higher the
number, the higher the precedence.
Description
Use the mld-snooping dot1p-priority command to configure 802.1p precedence for MLD messages
in a VLAN.
Use the undo mld-snooping dot1p-priority command to restore the default.
The default 802.1p precedence for MLD messages is 0.
Before configuring this command in a VLAN, enable MLD snooping in the VLAN.
Related commands: mld-snooping enable.
Examples
# Enable MLD snooping in VLAN 2 and set 802.1p precedence for MLD messages in the VLAN to 3.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping dot1p-priority 3
mld-snooping enable
Syntax
mld-snooping enable
undo mld-snooping enable