1-1
1 MAC Address Table Management Configuration
Commands
This chapter describes the management of static, dynamic, and blackhole MAC address entries. For
information about the management of multicast MAC address entries, refer to the “Multicast Protocol”
part of the manual.
MAC Address Table Management Configuration Commands
display mac-address aging-time
Syntax
display mac-address aging-time
View
Any view
Parameters
None
Description
Use the display mac-address aging-time command to display the aging time of the dynamic MAC
address entries in the MAC address table.
Related commands: mac-address, mac-address timer, display mac-address.
Examples
# Display the aging time of the dynamic MAC address entries.
<Sysname> display mac-address aging-time
Mac address aging time: 300s
The output information indicates that the aging time of the dynamic MAC address entries is 300
seconds.
<Sysname> display mac-address aging-time
Mac address aging time: no-aging
The output information indicates that dynamic MAC address entries do not age out.
To Next Page
Loading...
Need help?
General