1-5
lacp enable
Syntax
lacp enable
undo lacp enable
View
Ethernet port view
Parameter
None
Description
Use the lacp enable command to enable LACP on the current port.
Use the undo lacp enable command to disable LACP.
By default, LACP is disabled on a port.
Example
# Enable the LACP protocol on Ethernet 1/0/1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] lacp enable
lacp port-priority
Syntax
lacp port-priority port-priority
undo lacp port-priority
View
Ethernet port view
Parameter
port-priority: Port priority, ranging from 0 to 65,535.
Description
Use the lacp port-priority command to set the priority of the current port.
Use the undo lacp port-priority command to restore the default port priority.
By default, the port priority is 32,768.
You can use the display link-aggregation verbose command or the display link-aggregation
interface command to check the configuration result.
Example
# Set the priority of Ethernet1/0/1 to 64.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] lacp port-priority 64
To Next Page
Loading...
Need help?
General