2-3
tftp put
Syntax
tftp tftp-server put source-file [ dest-file ]
View
User view
Parameters
tftp-server: IP address or the host name of a TFTP server, a string of 1 to 20 characters. If the switch
belongs to a cluster, the value cluster means to connect to the TFTP server of the cluster. For the
configuration of the TFTP server of a cluster, refer to the Cluster part in this manual.
source-file: Name of the file to be uploaded to the TFTP server.
dest-file: File name used when a file is uploaded and saved to a TFTP server.
Description
Use the tftp put command to upload a file to a specified directory on a TFTP server.
When uploading files to a TFTP server, you can only select the files under the current working directory
of the device. To upload files in another directory, use the cd command to change to the specified
directory in user view before executing the tftp put command. For the execution of the cd command,
refer to the File System Management part in this manual.
Related commands: tftp get.
Examples
# Upload file config.cfg to the TFTP server whose IP address is 1.1.1.1 and save it as temp.cfg.
<Sysname> tftp 1.1.1.1 put config.cfg temp.cfg
File will be transferred in binary mode.
Copying file to remote tftp server. Please wait... /
TFTP: 962 bytes sent in 0 second(s).
File uploaded successfully.
tftp-server acl
Syntax
tftp-server acl acl-number
undo tftp-server acl
View
System view
Parameters
acl-number: Basic ACL number, in the range 2000 to 2999.
Description
Use the tftp-server acl command to specify the ACL adopted for the connection between a TFTP client
and a TFTP server.
Use the undo tftp-server acl command to cancel all ACLs adopted.
To Next Page
Loading...
Need help?
General