1-5
Parameters
interface-list: List of Ethernet ports. You can specify multiple Ethernet ports by providing this argument
in the form of interface-list = { interface-type interface-number [ to interface-type interface-number ] }
&<1-10>, where &<1-10> means that you can provide up to 10 port indexes/port index ranges for this
argument.
Description
Use the mac-authentication interface command to enable the MAC address authentication for on the
specified port(s).
Use the undo mac-authentication interface command to disable the MAC address authentication for
the specified port(s).
By default, MAC address authentication is disabled on a port.
z This command is essential for MAC address authentication to work on a port or on particular ports
after MAC address authentication is globally enabled.
z You cannot configure the maximum number of dynamic MAC address entries for a port (through
the mac-address max-mac-count command) with MAC address authentication enabled.
Likewise, you cannot enable the MAC address authentication feature on a port with a limit of
dynamic MAC addresses configured.
z If you have enabled MAC address authentication on a port, you cannot add the port to an
aggregation group. If a port is already added to an aggregation group, you cannot enable MAC
address authentication on the port.
Examples
# Enable MAC address authentication for Ethernet1/0/1 port.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] mac-authentication interface Ethernet 1/0/1
mac-authentication authmode usernameasmacaddress
Syntax
mac-authentication authmode usernameasmacaddress [ usernameformat { with-hyphen |
without-hyphen } ] { lowercase | uppercase } | fixedpassword password ]
undo mac-authentication authmode usernameasmacaddress { usernameformat |
fixedpassword }
View
System view
To Next Page
Loading...
Need help?
General