1-57
secondary accounting
Syntax
secondary accounting { ip-address | ipv6 ipv6-address } [ port-number ] [ key string ]
undo secondary accounting
View
RADIUS scheme view
Parameters
ip-address: IP address of the secondary accounting server to be used, in dotted decimal notation.
ipv6 ipv6-address: IPv6 address of the secondary accounting server.
port-number: UDP port number of the secondary accounting server, ranging from 1 to 65535.
key string: Specifies the shared key for exchanging accounting packets with the secondary RADIUS
accounting server. A shared key is a case-sensitive string of 1 to 16 characters.
Description
Use the secondary accounting command to set the IP address, port number and shared key of the
secondary RADIUS accounting server to be used by the current scheme.
Use the undo secondary accounting command to restore the default IP address and port number of
the secondary RADIUS accounting server, which are 0.0.0.0 and 1813 respectively.
Note that:
z Up to 16 secondary accounting servers are supported in a RADIUS scheme.
z You can configure a shared key for the secondary accounting server by specifying key string in this
command. The shared key configured in this command is used in preference. If key string is not
configured here, the shared key configured in the key command in RADIUS scheme view will be
used.
z The IP addresses of the primary and secondary accounting servers cannot be the same. Otherwise,
the configuration fails.
Related commands: key, radius scheme, state.
Examples
# Set the IP address and UDP port number of the secondary accounting server for RADIUS scheme
radius1 to 10.110.1.1 and 1813 respectively.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme radius1
New Radius scheme
[Sysname-radius-radius1] secondary accounting 10.110.1.1 1813
secondary authentication
Syntax
secondary authentication { ip-address | ipv6 ipv6-address } [ port-number ] [ key string ]
undo secondary authentication
To Next Page
Loading...
Need help?
General