1-17
<Sysname> reset logbuffer
reset trapbuffer
Syntax
reset trapbuffer [ unit unit-id ]
View
User view
Parameter
unit-id: Unit ID of the device, the value can only be 1.
Description
Use the reset trapbuffer command to clear information recorded in the trap buffer.
Example
# Clear information recorded in the trap buffer.
<Sysname> reset trapbuffer
terminal debugging
Syntax
terminal debugging
undo terminal debugging
View
User view
Parameter
None
Description
Use the terminal debugging command to enable debugging terminal display.
Use the undo terminal debugging command to disable debugging terminal display.
By default, debugging terminal display is disabled.
You can execute the terminal debugging command to display debugging information on a user
terminal.
Related command: debugging commands in the System Maintenance and Debugging module of the
manual.
Example
# Enable debugging terminal display.
<Sysname> terminal debugging
terminal logging
Syntax
terminal logging
undo terminal logging
To Next Page
Loading...
Need help?
General