2-46
Parameters
mac-address mac-address: Displays the structure of the standard topology three layers above or
below the node specified by the MAC address.
member member-id: Displays the structure of the standard topology three layers above or below the
node specified by the member ID.
Description
Use the display cluster base-topology command to display the standard topology of the cluster.
The standard topology of a cluster refers to the topology saved through the topology save-to
command. The standard topology is the backup of the normal topology information of a cluster and is
mainly used to resume the normal topology of the cluster member devices in case the cluster topology
encounters a fault.
Examples
# Display the standard topology of the cluster.
<aaa_0.Sysname> display cluster base-topology
--------------------------------------------------------------------
(PeerPort) ConnectFlag (NativePort) [SysName:DeviceMac]
--------------------------------------------------------------------
[aaa_0.Sysname:000f-e202-2180]
|
├-(P_0/40)<-->(P_0/6)[Sysname:000f-e200-2200]
|
├-(P_0/28)<-->(P_3/0/1)[Sysname:000f-e200-1774]
|
├-(P_0/22)<-->(P_1/0/2)[aaa_5.Sysname:000f-e200-5111]
|
├-(P_0/18)<-->(P_3/0/2)[Sysname S3100:000f-e218-d0d0]
|
├-(P_0/14)<-->(P_1/0/2)[Sysname:000f-e200-5601]
|
â””-(P_0/4)<-->(P_0/2)[S3100:000f-e200-00cc]
The output information of the display cluster base-topology command is in the following format:
(peer port number)<-->(local port number)[peer device name:peer device MAC address]
For example, (P_0/40)<-->(P_0/6)[Sysname:000f-e200-2200] means that the peer device uses its port
Ethernet 1/0/40 to connect to port Ethernet 1/0/6 of the local device; the peer device name is Sysname;
the MAC address of the peer device is 000f-e200-2200.
display cluster black-list
Syntax
display cluster black-list
View
Any view
To Next Page
Loading...
Need help?
General