1-7
[Sysname] interface Ethernet 1/0/3
[Sysname-Ethernet1/0/3] poe max-power 15000
poe mode
Syntax
poe mode { signal | spare }
undo poe mode
View
Ethernet port view
Parameter
signal: Supplies power through a signal cable.
spare: Supplies power through a spare cable.
Description
Use the poe mode command to configure the PoE mode on the current port.
Use the undo poe mode command to restore the PoE mode on the current port to the default mode.
By default, signal mode is adopted on a port.
Note that the S3100 series switches do not support the spare mode currently.
Example
# Set the PoE mode on Ethernet 1/0/3 to signal.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/3
[Sysname-Ethernet1/0/3] poe mode signal
poe power-management
Syntax
poe power-management { auto | manual }
undo poe power-management
View
System view
Parameter
auto: Adopts the auto mode, namely, a PoE management mode based on PoE priority of the port.
manual: Adopts the manual mode.
Description
Use the poe power-management command to configure the PoE management mode of port used in
the case of power overloading.
Use the undo poe power-management command to restore the default mode.
By default, the PoE management mode on port is auto.
To Next Page
Loading...
Need help?
General