1-1
1 IP Address Configuration Commands
IP Address Configuration Commands
display ip interface
Syntax
display ip interface [ interface-type interface-number ]
View
Any view
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Description
Use the display ip interface command to display information about a specified or all Layer 3
interfaces.
If no argument is specified, information about all Layer 3 interfaces is displayed.
Examples
# Display information about VLAN-interface 1.
<Sysname> display ip interface Vlan-interface 1
Vlan-interface1 current state :UP
Line protocol current state :UP
Internet Address is 192.168.0.39/24 Primary
Broadcast address : 192.168.0.255
The Maximum Transmit Unit : 1500 bytes
IP packets input number: 9678, bytes: 475001, multicasts: 7
IP packets output number: 8622, bytes: 391084, multicasts: 0
TTL invalid packet number: 0
ICMP packet input number: 0
Echo reply: 0
Unreachable: 0
Source quench: 0
Routing redirect: 0
Echo request: 0
Router advert: 0
Router solicit: 0
Time exceed: 0
IP header bad: 0
Timestamp request: 0
To Next Page
Loading...
Need help?
General