1-27
With line rate (LR) applied on one port in the inbound direction or the Traffic Policing enabled, multicast
suppression cannot be enabled on any port of the device, and vice versa. Refer to the QoS part for
information about LR and Traffic Policing.
Example
# Set the maximum amount of unknown multicast and unknown unicast bits that can be received per
second by Ethernet 1/0/2 to 128 kbps.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet1/0/2
[Sysname-Ethernet1/0/2] multicast-suppression bps 128
port
Syntax
port interface-list
undo port interface-list
View
Port group view
Parameter
interface-list: Ethernet interface list, in the format of interface-type interface-number [ to interface-type
interface-number ] &<1-10>, where &<1-10> indicates that you can specify up to 10 port ranges.
Description
Use the port command to add Ethernet interface(s) to a specified port group.
Use the undo group-member command to remove specified Ethernet interface(s) from a port group.
By default, a port group is empty, that is, there is no Ethernet interface in it.
A port can not be added to a port group if it has been added to an aggregation group, and vice versa.
Example
# Add interfaces Ethernet 1/0/2 through Ethernet 1/0/5 to port group 1.
<Sysname> system-view
[Sysname] port-group 1
[Sysname-port-group-1] port Ethernet 1/0/2 to Ethernet 1/0/5
To Next Page
Loading...
Need help?
General