1-10
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] cfd mep service-instance 5 mep 3 enable
cfd meplist
Syntax
cfd meplist mep-list service-instance instance-id
undo cfd meplist mep-list service-instance instance-id
View
System view
Default Level
2: System level
Parameters
meplist mep-list: Specifies a list of MEP IDs, indicating multiple MEPs, in the format of mep-list =
{ mep-id [ to mep-id ] }&<1-10>, in which mep-id represents the MEP ID and ranges from 1 to 8191.
&<1-10> indicates you can specify up to 10 MEP ID ranges.
service-instance instance-id: Specifies the service instance ID, ranging from 1 to 32767.
Description
Use the cfd meplist command to create a MEP list, which is a collection of local MEPs allowed to be
configured and the remote MEPs to be monitored.
Use the undo cfd meplist command to delete existing MEP lists.
By default, no MEP list is created.
Note that:
z Before creating a MEP list, you need to create the corresponding MD, MA, and service instance.
z After you delete a MEP list, all local MEP configurations based on this list will be deleted.
Related commands: cfd ma, cfd md, cfd service-instance.
Examples
# Create a MEP list that includes MEP 9 through MEP 15 in service instance 5.
<Sysname> system-view
[Sysname] cfd md test_md level 3
[Sysname] cfd ma test_ma md test_md vlan 100
[Sysname] cfd service-instance 5 md test_md ma test_ma
[Sysname] cfd meplist 9 to 15 service-instance 5
cfd mip-rule
Syntax
cfd mip-rule { explicit | default } service-instance instance-id
undo cfd mip-rule service-instance instance-id
View
System view
To Next Page
Loading...
Need help?
General