1-31
[Sysname] display ssh user-information
Username Authentication-type User-public-key-name Service-type
1 publickey 127.0.0.1 stelnet
ssh user authentication-type
Syntax
ssh user username authentication-type { all | password | password-publickey | publickey | rsa }
undo ssh user username authentication-type
View
System view
Parameters
username: SSH user name, a string of 1 to 184 characters. It cannot contain any of these characters:
slash (/), backslash (\), colon (:), asterisk (*), question mark (?), less than sign (<), greater than sign (>),
and the vertical bar sign (|). In addition, the @ sign can appear up to once, the username part (that is,
the string before the @ sign) cannot be more than 55 characters, and the domain name part cannot be
more than 128 characters.
all: Specifies that the authentication mode for the SSH user can be either password authentication or
publickey authentication.
password: Specifies the authentication mode for the SSH user as password authentication.
password-publickey: Specifies the authentication mode for the SSH user as password and publickey.
publickey: Specifies the authentication mode for the SSH user as publickey (RSA key or DSA key )
authentication.
rsa: Specifies the authentication mode for the SSH user as publickey (RSA key or DSA key )
authentication. The authentication modes specified by the rsa keyword and publickey keyword are
implemented in the same way
For the password-publickey authentication type:
z SSH1 client users can access the switch as long as they pass one of the two authentications.
z SSH2 client users can access the switch only when they pass both the authentications.
Description
Use the ssh user authentication-type command to specify the authentication mode for SSH users on
the server.
Use the undo ssh user authentication-type command to remove the configuration.
To Next Page
Loading...
Need help?
General