1-28
port-group
Syntax
port-group
undo port-group
View
System view
Parameter
group-id: Number of port group, in the range of 1 to 100.
Description
Use the port-group command to create a port group or enter the specified port group view.
By default, no port group is configured.
Only S3100-EI Series Ethernet Switches support Port Group feature.
Example
# Create port group 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] port-group 1
[Sysname-port-group-1]
reset counters interface
Syntax
reset counters interface [ interface-type | interface-type interface-number ]
View
User view
Parameter
interface-type: Port type.
interface-number: Port number.
For details about the parameters, see the parameter description of the interface command.
Description
Use the reset counters interface command to clear the statistics of the port, preparing for a new
statistics collection.
If you specify neither port type nor port number, the command clears statistics of all ports.
If specify only port type, the command clears statistics of all ports of this type.
If specify both port type and port number, the command clears statistics of the specified port.
To Next Page
Loading...
Need help?
General