1-1
1 CLI Configuration Commands
CLI Configuration Commands
command-privilege level
Syntax
command-privilege level level view view command
undo command-privilege view view command
View
System view
Parameters
level level: Command level to be set, in the range of 0 to 3.
view view: CLI view. It can be any CLI view that the Ethernet switch supports. The S3100 series support
only the CLI views listed in
Table 1-1:
Table 1-1 Available CLI views for the view argument
CLI view Description
acl-adv Advanced ACL view
acl-basic Basic ACL view
acl-ethernetframe
Layer 2 ACL view, which is supported by only the S3100-EI
series
acl6-adv
Advanced IPv6 ACL view, which is supported by only the
S3100-EI series
acl6-basic
Basic IPv6 ACL view, which is supported by only the
S3100-EI series
aux Aux 1/0/0 port view, that is, console port view
cert-acp PKI certificate attribute-based access control policy view
cert-attribute-group PKI certificate attribute group view
cluster Cluster view
dhcp-pool
DHCP address pool view, which is supported by only the
S3100-EI series
ethernet 100M Ethernet port view
ftp-client FTP client view
gigabitethernet GigabitEthernet port view
gqinq QinQ view, which is supported by only the S3100-EI series
hwping HWPing test group view
To Next Page
Loading...
Need help?
General