1-5
Examples
# Set the maximum ARP packet receiving rate on Ethernet 1/0/11 to 100 pps.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet 1/0/11
[Sysname-Ethernet1/0/11] arp rate-limit enable
[Sysname-Ethernet1/0/11] arp rate-limit 100
arp rate-limit enable
Syntax
arp rate-limit enable
undo arp rate-limit enable
View
Ethernet port view
Parameters
None
Description
Use the arp rate-limit enable command to enable the ARP packet rate limit function on the port, that is,
to limit the rate of ARP packets passing through the port. If a rate (the maximum ARP packet rate is 15
pps by default) is specified, exceeding ARP packets will be discarded.
Use the undo arp rate-limit enable command to disable the ARP packet rate limit function on the port.
By default, the ARP packet rate limit function is disabled, that is, ARP packet rate is not limited on a port.
Note that among S3100 series switches, only S3100-EI series switches support the two commands.
Examples
# Enable the ARP packet rate limit function on Ethernet 1/0/11.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/11
[Sysname-Ethernet1/0/11] arp rate-limit enable
arp restricted-forwarding enable
Syntax
arp restricted-forwarding enable
undo arp restricted-forwarding enable
View
VLAN view
To Next Page
Loading...
Need help?
General