1-6
Note that, this command displays GVRP statistics only on the trunk ports included in the list. Statistics
on non-trunk ports will not be displayed.
Description
Use the display gvrp statistics command to display the GVRP statistics of trunk ports.
This command displays the following information:
z GVRP status
z Number of the GVRP entries that fail to be registered
z Source MAC address of the previous GVRP PDU
z GVRP registration type of a port
Examples
# Display the GVRP statistics of Ethernet1/0/1, assuming that the port is a trunk port.
<Sysname> display gvrp statistics interface Ethernet 1/0/1
GVRP statistics on port Ethernet1/0/1
GVRP Status : Enabled
GVRP Failed Registrations : 0
GVRP Last Pdu Origin : 0000-0000-0000
GVRP Registration Type : Normal
display gvrp status
Syntax
display gvrp status
View
Any view
Parameters
None
Description
Use the display gvrp status command to display the global GVRP status (enabled or disabled).
Examples
# Display the global GVRP status.
<Sysname> display gvrp status
GVRP is enabled
The above information indicates that GVRP is enabled globally.
gvrp
Syntax
gvrp
undo gvrp
View
System view, Ethernet port view
To Next Page
Loading...
Need help?
General