2-6
host-aging-time (MLD-Snooping view)
Syntax
host-aging-time interval
undo host-aging-time
View
MLD-Snooping view
Default Level
2: System level
Parameters
interval: Dynamic member port aging time, in units of seconds. The effective range is 200 to 1,000.
Description
Use the host-aging-time command to configure the aging time of dynamic member ports globally.
Use the undo host-aging-time command to restore the default setting.
By default, the aging time of dynamic member ports is 260 seconds.
Related commands: mld-snooping host-aging-time.
Examples
# Set the aging time of dynamic member ports globally to 300 seconds.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] host-aging-time 300
last-listener-query-interval (MLD-Snooping view)
Syntax
last-listener-query-interval interval
undo last-listener-query-interval
View
MLD-Snooping view
Default Level
2: System level
Parameters
interval: MLD last listener query interval in units of seconds, namely the length of time the device waits
between sending MLD multicast-address-specific queries. The effective range is 1 to 5.
Description
Use the last-listener-query-interval command to configure the MLD last listener query interval
globally.
Use the undo last-listener-query-interval command to restore the system default.
By default, the MLD last listener query interval is 1 second.
Related commands: mld-snooping last-listener-query-interval.
To Next Page
Loading...
Need help?
General