1-16
lldp compliance cdp
Syntax
lldp compliance cdp
undo lldp compliance cdp
View
System view
Parameters
None
Description
Use the lldp compliance cdp command to enable CDP compatibility globally.
Use the undo lldp compliance cdp command to restore the default.
By default, CDP compatibility is disabled globally.
Notes that:
z Of the S3100 series, only the S3100-EI series switches support the CDP compatibility function.
z As the maximum TTL allowed by CDP is 255 seconds, ensure that the product of the TTL
multiplier and the LLDPDU transmit interval is less than 255 seconds for CDP-compatible LLDP to
work properly with Cisco IP phones. You can use lldp hold-multiplier command to configure the
TTL multiplier and use lldp timer tx-interval command to configure the LLDPDU transmit interval.
Related commands: lldp hold-multiplier, lldp timer tx-interval.
Examples
# Enable LLDP to be compatible with CDP globally.
<Sysname> system-view
[Sysname] lldp compliance cdp
lldp enable
Syntax
lldp enable
undo lldp enable
View
System view, Ethernet interface view
Parameters
None
Description
Use the lldp enable command to enable LLDP.
Use the undo lldp enable command to disable LLDP.
To Next Page
Loading...
Need help?
General