2-22
mld-snooping static-router-port
Syntax
mld-snooping static-router-port vlan vlan-id
undo mld-snooping static-router-port vlan vlan-id
View
Ethernet interface view
Default Level
2: System level
Parameters
vlan vlan-id: Specifies a VLAN in which one or more static router ports are to be configured, where
vlan-id is in the range of 1 to 4094.
Description
Use the mld-snooping static-router-port command to configure the current port(s) as static router
port(s).
Use the undo mld-snooping static-router-port command to restore the system default.
By default, no ports are static router ports.
Note that:
z This command works on MLD snooping–enabled VLANs.
z If configured in Ethernet interface view, this feature takes effect only if the interface belongs to the
specified VLAN.
Examples
# Enable the static router port function on Ethernet 1/0/1 in VLAN 2.
<Sysname> system-view
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] mld-snooping static-router-port vlan 2
mld-snooping version
Syntax
mld-snooping version version-number
undo mld-snooping version
View
VLAN view
Default Level
2: System level
Parameters
version-number: MLD snooping version, in the range of 1 to 2.
Description
Use the mld-snooping version command to configure the MLD snooping version.
To Next Page
Loading...
Need help?
General