1-4
Field Description
3 times matched
Number of times that the rule has been matched. Only matches where the
ACL is referenced by upper layer software are counted. Note that this field
is displayed on only S3100-SI series Ethernet switches.
display acl remaining entry
Syntax
display acl remaining entry
View
Any view
Parameter
None
Description
Use the display acl remaining entry command to display information about the remaining ACL
resources.
According to the output, you can determine the number of resources consumed by a certain type of ACL
rules and whether the exhaustion of resources causes the failure to assign ACL rules.
Only H3C S3100-EI series switches support this command.
Example
# Display information about the remaining ACL resources.
<Sysname> display acl remaining entry
Resource Total Reserved Configured Remaining Start End
Type Number Number Number Number Port Name Port Name
--------------------------------------------------------------------------
Rule 1024 13 1 1010 Eth1/0/1 GE1/2/1
Table 1-2 Description on the fields of the display acl remaining entry command
Field Description
Resource Type
Resource type, Rule: number of rule resources that the switch can
assign
Total Number Total number of ACL resources
Reserved Number Number of resources reserved for system ACLs
Configured Number Number of resources configured for user-defined ACLs
To Next Page
Loading...
Need help?
General