1-6
display debugging
Syntax
display debugging [ unit unit-id ] [ interface interface-type interface-number ] [ module-name ]
View
Any view
Parameter
unit-id: Unit ID of a switch, the value can only be 1.
interface-type: Interface type.
interface-number: Interface number.
module-name: Functional module name.
Description
Use the display debugging command to display enabled debugging on a specified device.
Example
# Display enabled debugging on unit 1.
<Sysname> display debugging unit 1
ARP packet debugging switch is on
TCP:
TCP packet debugging switch is on for task any socket any
IP icmp debugging is on
display version
Syntax
display version
View
Any view
Parameter
None
Description
Use the display version command to display the version information about the switch system.
Specifically, you can use this command to check the software version and release time, the basic
hardware configuration, and some other information about the switch.
Example
# Display the version information of the system.
<Sysname> display version
H3C Comware Platform Software.
Comware Software, Version 3.10, Alpha 2101
Copyright (c) 2004-2007 Hangzhou H3C Technologies Co., Ltd. All rights reserved.
H3C S3100-26TP-EI-W uptime is 0 week, 0 day, 19 hours, 40 minutes
H3C S3100-26TP-EI-W with 1 Processor
To Next Page
Loading...
Need help?
General