4-12
[Sysname] acl ipv6 number 3000
[Sysname-acl6-adv-3000] rule 0 permit tcp source 2030:5060::9050/64
[Sysname-acl6-adv-3000] rule 0 comment This rule is used in eth 1/1
step (for IPv6)
Syntax
step step-value
undo step
View
Basic IPv6 ACL view, advanced IPv6 ACL view
Default Level
2: System level
Parameters
step-value: IPv6 ACL rule numbering step, in the range 1 to 20.
Description
Use the step command to set a rule numbering step for an IPv6 ACL.
Use the undo step command to restore the default.
By default, the rule numbering step is five.
Examples
# Set the rule numbering step to 2 for IPv6 ACL 2000.
<Sysname> system-view
[Sysname] acl ipv6 number 2000
[Sysname-acl6-basic-2000] step 2
# Set the rule numbering step to 2 for IPv6 ACL 3000.
<Sysname> system-view
[Sysname] acl ipv6 number 3000
[Sysname-acl6-adv-3000] step 2
IPv6 Multicast Group Filter Configuration Commands
group-policy (MLD-Snooping view)
Syntax
group-policy acl6-number [ vlan vlan-list ]
undo group-policy [ vlan vlan-list ]
View
MLD-Snooping view
Default Level
2: System level
To Next Page
Loading...
Need help?
General