1-5
Examples
# Set the GARP LeaveAll timer to 100 centiseconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] garp timer leaveall 100
reset garp statistics
Syntax
reset garp statistics [ interface interface-list ]
View
User view
Parameters
interface-list: Specifies a list of Ethernet ports. In this list, you can specify individual ports and port
ranges. An individual port takes the form of interface-type interface-number and a port range takes the
form of interface-type interface-number1 to interface-type interface-number2, with interface-number2
taking a value greater than interface-number1. The total number of individual ports and port ranges
defined in the list must not exceed 10.
Description
Use the reset garp statistics command to clear the GARP statistics (including statistics about packets
received/sent/discarded by GVRP) on the specified or all ports.
Executing the reset garp statistics command without any parameter clears the GARP statistics of all
ports.
Related commands: display garp statistics.
Examples
# Clear GARP statistics of all ports.
<Sysname> reset garp statistics
GVRP Configuration Commands
display gvrp statistics
Syntax
display gvrp statistics [ interface interface-list ]
View
Any view
Parameters
interface interface-list: Specifies an Ethernet port list. By providing a value for this argument, you can
display the GVRP statistics on the specified ports. You need to provide the interface-list argument in the
format of { interface-type interface-number [ to interface-type interface-number ] } &<1-10>, where the
interface-type argument represents the port type, the interface-number argument represents the port
number, and & <1-10> means that you can provide up to 10 port indexes/port index ranges for this
argument.
To Next Page
Loading...
Need help?
General