H3C S3100 Series Command Manual

2-3
Examples
# View the statistics information of all kinds of MLD messages learned by MLD snooping.
<Sysname> display mld-snooping statistics
Received MLD general queries:0.
Received MLDv1 specific queries:0.
Received MLDv1 reports:0.
Received MLD dones:0.
Sent MLDv1 specific queries:0.
Received MLDv2 reports:0.
Received MLDv2 reports with right and wrong records:0.
Received MLDv2 specific queries:0.
Received MLDv2 specific sg queries:0.
Sent MLDv2 specific queries:0.
Sent MLDv2 specific sg queries:0.
Received error MLD messages:0.
Table 2-2 display mld-snooping statistics command output description
Field Description
general queries
General query messages
specific queries
Multicast-address-specific query messages
reports
Report messages
dones Done messages
reports with right and wrong records
Reports containing correct and incorrect records
specific sg queries
Multicast-address-and-source-specific queries
error MLD messages
Error MLD messages
dot1p-priority (MLD-Snooping view)
Syntax
dot1p-priority priority-number
undo dot1p-priority
View
MLD-Snooping view
Default Level
2: System level
Parameters
priority-number: Specifies 802.1p precedence for MLD messages, in the range of 0 to 7. The higher the
number, the higher the precedence.
Description
Use the dot1p-priority command to configure 802.1p precedence for MLD messages globally.
Use the undo dot1p-priority command to restore the default.
The default 802.1p precedence for MLD messages is 0.

H3C S3100 Series Specifications

General

Brand	H3C
Model	S3100 Series
Category	Switch
Language	English