H3C S3100 Series

1-4
undo copyright-info enable
View
System view
Parameters
None
Description
Use the copyright-info enable command to enable copyright information displaying.
Use the undo copyright-info enable command to disable copyright information displaying.
By default, copyright information displaying is enabled. That is, the copyright information is displayed
after a user logs into a switch successfully.
Note that these two commands apply to users logging in through the console port and by means of
Telnet.
Examples
# Disable copyright information displaying.
**************************************************************************
* Copyright (c) 2004-2008 Hangzhou H3C Tech. Co., Ltd. All rights reserved.*
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
**************************************************************************
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] undo copyright-info enable
# After the above configuration, no copyright information is displayed after a user logs in, as shown
below.
<Sysname>
databits
Syntax
databits { 7 | 8 }
undo databits
View
AUX user interface view
Parameters
7: Sets the databits to 7.
8: Sets the databits to 8.
Description
Use the databits command to set the databits for the user interface.