1-21
dot1x timer reauth-period
Syntax
dot1x timer reauth-period reauth-period-value
undo dot1x timer reauth-period
View
System view
Parameter
reauth-period reauth-period-value: Specifies re-authentication interval, in seconds. After this timer
expires, the switch initiates 802.1x re-authentication. The value of the reauth-period-value argument
ranges from 60 to 7,200.
Description
Use the dot1x timer reauth-period command to configure the interval for 802.1x re-authentication.
Use the undo dot1x timer reauth-period command to restore the default 802.1x re-authentication
interval.
By default, the 802.1x re-authentication interval is 3,600 seconds.
Example
# Set the 802.1x re-authentication interval to 150 seconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] dot1x timer reauth-period 150
dot1x unicast-trigger
Syntax
dot1x unicast-trigger
undo dot1x unicast-trigger
View
Ethernet interface view
Parameters
None
Description
Use the dot1x unicast-trigger command to enable the unicast trigger function of 802.1X on a port.
With this function enabled, the port, upon receiving a frame whose source MAC address is not in the
MAC address table, will unicast a EAP request to that MAC address.
Use the undo dot1x unicast-trigger command to disable this function.
By default, the unicast trigger function is disabled.
Note that, currently, only the S3100-EI series support this two commands.
To Next Page
Loading...
Need help?
General