1-68
Traffic-unit : B
Packet traffic-unit : one-packet
display stop-accounting-buffer
Syntax
display stop-accounting-buffer hwtacacs-scheme hwtacacs-scheme-name
View
Any view
Parameters
hwtacacs-scheme hwtacacs-scheme-name: Displays the buffered stop-accounting requests of a
specified HWTACACS scheme. Here, hwtacacs-scheme-name is a string of up to 32 characters.
Description
Use the display stop-accounting-buffer command to display stop-accounting requests buffered in the
switch.
Related commands: reset stop-accounting-buffer, stop-accounting-buffer enable, retry
stop-accounting.
Examples
# Display stop-accounting requests buffered for HWTACACS scheme hwt1.
<Sysname> display stop-accounting-buffer hwtacacs-scheme hwt1
hwtacacs nas-ip
Syntax
hwtacacs nas-ip ip-address
undo hwtacacs nas-ip
View
System view
Parameters
ip-address: Source IP address to be set, an IP address of this device. This address can neither be the
all 0's address nor be a Class D address.
Description
Use the hwtacacs nas-ip command to set the source address of outgoing HWTACACS messages.
Use the undo hwtacacs nas-ip command to restore the default setting.
By default, no source address is specified, and the IP address of corresponding outbound interface is
used as the source address.
Note that:
To Next Page
Loading...
Need help?
General