H3C S3100 Series

1-16
The frequency command does not apply to DHCP tests.
Examples
# Set the automatic test interval to 10 seconds in an ICMP test.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator icmp
[Sysname-hwping-administrator-icmp] test-type icmp
[Sysname-hwping-administrator-icmp] destination-ip 169.254.10.3
[Sysname-hwping-administrator-icmp] frequency 10
ftp-operation
Syntax
ftp-operation { get | put }
View
HWPing test group view
Parameters
get: Specifies the test operation as download from the FTP server.
put: Specifies the test operation as upload to the FTP server.
Description
Use the ftp-operation command to configure the FTP operation mode, which can be get and put.
By default, the FTP operation mode is get.
Related commands: username, password.
The ftp-operation command applies to FTP tests only.
Examples
# Set the FTP operation mode to put in an FTP test.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator ftp
[Sysname-hwping-administrator-ftp] test-type ftp
[Sysname-hwping-administrator-ftp] ftp-operation put
history keep-time
Syntax
history keep-time keep-time
undo history keep-time