1-6
Table 1-1 Description on the fields of the display qos-global command
Field Description
Inbound Packet direction
Matches ACL rules for traffic classifying
Target rate Traffic policing target rate
Conform action Action conducted to packet conforming to the traffic specification
Exceed action Action conducted to packets exceeding the traffic specification
meter-statistic running
The function of collecting traffic policing statistics information is
enabled (meter-statistic not running indicates that the function is not
enabled)
62284 byte outprofile Size of the packets exceeding the traffic specification (in bytes)
82521 byte inprofile Size of the packets conforming to the traffic specification (in bytes)
display qos-interface all
Syntax
display qos-interface { interface-type interface-number | unit-id } all
View
Any view
Parameter
interface-type interface-number: Specifies the type and number of a port, for which the QoS
configuration information is to be displayed.
unit-id: Unit ID, which is fixed to 1. With this argument specified, the QoS-related configuration of all the
ports on the device is displayed.
Description
Use the display qos-interface all command to display the QoS-related configuration of a port or all the
ports on the device.
Example
# Display the QoS-related configuration of Ethernet 1/0/1.
<Sysname> display qos-interface Ethernet 1/0/1 all
Ethernet1/0/1: line-rate
Inbound: 1024 Kbps
Ethernet1/0/1:
Queue scheduling mode: weighted round robin
weight of queue 0: 12
weight of queue 1: 8
weight of queue 2: 4
To Next Page
Loading...
Need help?
General