1-5
z You cannot configure a member port of an aggregation group, or a port enabled with LACP or STP
as the destination port.
z Before configuring a destination port for a local mirroring group, make sure that the corresponding
mirroring group has already been created.
z It is recommended that you use a destination port for port mirroring purpose only. Do not use a
destination port to transmit other service packets.
Related commands: display mirroring-group.
Examples
# Configure Ethernet 1/0/4 as the destination port of local mirroring group 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] mirroring-group 1 local
[Sysname] mirroring-group 1 monitor-port Ethernet 1/0/4
mirroring-group reflector-port
Syntax
mirroring-group group-id reflector-port reflector-port
undo mirroring-group group-id reflector-port reflector-port
View
System view, Ethernet port view
Parameters
group-id: Number of a port mirroring group, the value of which can only be 1.
reflector-port reflector-port: Specifies the reflector port.
Description
Use the mirroring-group reflector-port command to specify the reflector port for a remote source
mirroring group.
Use the undo mirroring-group reflector-port command to remove the reflector port of a remote
source mirroring group.
Note the following when you configure the reflector port:
z The reflector port cannot be a member port of an aggregation group, or a port enabled with LACP
or STP. It must be an access port and cannot be configured with the functions like VLAN-VPN, port
loopback detection, packet filtering, QoS, port security, and so on.
z You cannot modify the duplex mode, port rate, and MDI attribute of a reflector port.
z It is recommended not to configure the VLAN mapping and the selective QinQ function on the
reflector port; otherwise, port mirroring may not function properly..
Examples
# Configure Ethernet 1/0/2 as the reflector port of remote source mirroring group 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] mirroring-group 1 remote-source
To Next Page
Loading...
Need help?
General