H3C S3100 Series - Display Poe Interface

1-1
1 PoE Configuration Commands
PoE Configuration Commands
display poe interface
Syntax
display poe interface [ interface-type interface-number ]
View
Any view
Parameter
interface-type interface-number: Port type and port number.
Description
Use the display poe interface command to view the PoE status of a specific port or all ports of the
switch.
If the interface-type interface-number argument is not specified, the command displays the PoE status
of all ports of the switch.
Related commands: poe enable, poe max-power, poe mode, poe power-management, poe
priority.
Example
# Display the PoE status of Ethernet 1/0/10.
<Sysname> display poe interface Ethernet1/0/10
Port power enabled :enable
Port power ON/OFF :on
Port power status :Standard PD was detected
Port power mode :signal
Port PD class :0
port power priority :low
Port max power :15400 mW
Port current power :460 mW
Port peak power :552 mW
Port average power :547 mW
Port current :10 mA
Port voltage :51 V