1-7
You can use the display link-aggregation verbose command to check the configuration result.
Example
# Set the description "abc" for aggregation group 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] link-aggregation group 1 description abc
link-aggregation group mode
Syntax
link-aggregation group agg-id mode { manual | static }
undo link-aggregation group agg-id
View
System view
Parameter
agg-id: Aggregation group ID, in the range of 1 to 52.
manual: Creates a manual aggregation group.
static: Creates a static aggregation group.
Description
Use the link-aggregation group mode command to create a manual or static aggregation group.
Use the undo link-aggregation group command to remove the specified aggregation group.
Related command: display link-aggregation summary.
Example
# Create manual aggregation group 22
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] link-aggregation group 22 mode manual
port link-aggregation group
Syntax
port link-aggregation group agg-id
undo port link-aggregation group
View
Ethernet port view
Parameter
agg-id: Aggregation group ID, in the range of 1 to 52.
Description
Use the port link-aggregation group command to add the current Ethernet port to a manual or static
aggregation group.
Use the undo port link-aggregation group command to remove the current Ethernet port from the
aggregation group.
To Next Page
Loading...
Need help?
General